Application of quartz and calcite microstructures and fluid inclusions on estimation of deformation condition and origin of the Zagros orogen thrust sheets in the Bakhtyari area

Abstract

Structural analysis of the High Zagros Zone and southwestern rim of the Sanandaj-Sirjan Zone in the Chaharmahal-va-Bakhtyari area resulted in recognition of a thrust system comprises the Ben, Hafshejan, Farsan, Kuhrang and Bazoft thrust sheets from NE to SW. In this study, quartz and calcite microstructures as well as fluid inclusions have been utilized to inspect deformation conditions of the thrust sheets. Microstructural study of quartz grains from the Ben and Hafshejan thrust sheets and their basal thrust zone show evidence of ductile deformation that demonstrate the deformation temperature from 250º to 350ºC for the sheets. Geothermometry study of the sheets using calcite mechanical twins also reveals temperature of 250ºC for the sheets. Fluid inclusions study on quartz veins from these thrust sheets display homogenization temperature up to 220ºC for primary inclusions. This geothermometry survey demonstrates that physical conditions of deformation do not change significantly but increases gradually from the southwestern rim of the Sanandaj-Sirjan Zone toward High Zagros Zone. Based on present data, the area between the Ben and Hafshejan thrust sheets where is considered as the internal part of the Zagros orogen, display characteristics of a transitional zone. Therefore, the Farsan thrust sheet or the Main Zagros Reverse Fault which is known as the margin between the Arabian Plate and Central Iran do not pose this character. The boundary between the Sanandaj-Sirjan Zone as the internal part and the High Zagros Zone as the external part of the Zagros orogene is not abrupt and occurs across a transitional zone comprises a thrust system where basement is also partially involved.

Keywords

References

[1] Coward M. P., "Balancing sections through inverted basins", Geological Society of London Special Publications 99 (1996) 51-77.

[2] Hatcher R. D. Jr., "Confirmation of Thin-skinned Thrust Faulting in Foreland Fold-Thrust Belts and Its Impact on Hydrocarbon Exploration: Bally, Gordy, and Stewart, Bulletin of Canadian Petroleum Geology, 1966", American Association of Petroleum Geologists article 70034 (2007) 4 p.

[3] Tozer R., Butler R.W.H., Corrado S., "Comparing thin-and thick-skinned thrust tectonic models of the Central Apennines, Italy", In: Bertotti, G., Schulmann, K., Cloetingh, S.A.P.L. (eds.), Continental collision and the tectono-sedimentary evolution of forelands, EGU Stephan Mueller Special Publication Series 1 (2002) 181-194.

[4] Hubbert M.K., Rubey W., "Role of fluid pressure in mechanics of overthrust faulting", Geological Society of America Bulletin 70 (1959) 115-205.

[5] Müller W.H., Hsü K.J., "Stress Distribution in overthrusting slabs and mechanics of Jura deformation", Rock Mechanics, Supplement 9 (1980) 219-232.

[6] Harris L. D., Milici R. C., "Characteristics of thin-skinned style of deformation in the southern Appalachians, and potential hydrocarbon traps", U.S. Geological Survey Professional Paper 1018 (1977) 40 p.

[7] Gilotti J.A., Kumpulainen R., "1986, Strain softening induced ductile flow in the Särv thrust sheet, Scandinavian Caledonides", Journal of Structural Geology 8 (1986) 441-455.

[8] Yassaghi A., James P. R., Flottmann T., "Geometric and kinematic evolution of asymmetric ductile shear zones in thrust sheets, southern Adelaide Fold–Thrust Belt, South Australia", Journal of Structural Geology 22 (2000) 889-912.

[9] Schmid S.M., "Microfabric studies as indicators of deformation mechanisms and flow laws operative in mountain building", In: Hsü , K.J. (Ed.), Mountain Building Processes, Academic Press, London (1982) 95-110.

[10] Yassaghi A., James P. R., Flöttmann T., Winsor C. N., "P–T conditions and kinematics of shear zones from the southern Adelaide Fold-Thrust Belt, South Australia: insights into the dynamics of a deeply eroded orogenic wedge", Australian Journal of Earth Sciences 51 (2004) 301-317.

[11] مفیدی ا.، یساقی ع.، رحیمی ب.، "تحلیل کرنش و ریزساختاردانه‌های کوارتز در برآورد خاستگاه و شرایط دگرشکلی برگه‌های راندگی البرز شرقی"، مجله بلورشناسی و کانی‌شناسی ایران، شماره 1 (1386) ص 3-22.

[12] O'Hara K.D., Haak A., "A fluid inclusion study of fluid pressure and salinity variations in the footwall of the Rector Branch thrust, North Carolina, U.S.A", Journal of Structural Geology 14 (1992) 579-589.

[13] Webe J. C., Ferrill D.A., "Roden-Tice, M.K.," Calcite and quartz microstructural geothermometry of low-grade metasedimentary rocks, Northern Range, Trinidad", Journal of Structural Geology 23 (2001) 93-212.

[14] Ferrill D.A., Morris A.P., Evans M.A., Burkhard M., Groshong R.H. Jr, Onasch C.M., "Calcite twin morphology: a low-temperature deformation geothermometer", Journal of Structural Geology 26 (2004) 1521‌-529.

[15] Hirth G., Tullis J., "Dislocation creep regimes in quartz aggregates", Journal of Structural Geology 14 (1992) 145-159.

[16] Burkhard M., "Calcite twins, their geometry, appearance and significance as stress–strain markers and indicators of tectonic regime: a review", Journal of Structural Geology 15(1993) 351-368.

[17] Hollister L. S., Burruss R. C., Henry D. L., Hendel E. M., "Physical conditions during uplift of metamorphic terranes as recorded by fluid inclusions", Bulletin Societe France, Mineralogie Crystallographie 102 (1979) 555-561.

[18] Yonkee W.A., Parry W.T., Bruhn R.L., Cashman P.C., "Thermal models of thrust faulting: Constraints from fluid inclusion observations, Willard thrust sheet, Idaho-Utah-Wyoming thrust belt", Geological Society of America Bulletin 101 (1989) 304-313.

[19] Shepherd T. J., Rankin A.H., Alderton D.H.M., "A practical guide to fluid inclusion studies", Chapman & Hall (1985) 239p.

[20] Nemati M., Yassaghi A., Kamali M.R., "Geometry and Kinematics of thrust sheets in the High Zagros zone at Bakhtyari area, Iran", Proceedings of 33rd International Geological Congress, Oslo (2008) session STT-06.

[21] Nemati M., Yassaghi A., "Structural characteristics of the transitional zone from internal to external parts of the Zagros orogen, Iran", Asian Journal of Earth Sciences 39 (2010) 161-172.

[22] NIOC, "Geological Map of Iran, Sheet No. 4, South-West Iran", National Iranian Oil Company, Exploration and Production Affairs (1975), Scale 1:1,000,000.

[23] Zahedi M., Samadian M., Tatevosian Sh., Amidi M., "Geological map of Esfahan", Geological Survey of Iran (1978), Scale 1:250,000.

[24] Zahedi M., Vaezipour J., Rahmati Ilkhchi M., "Geological map of Shhrekord", Geological Survey of Iran (1993), Scale 1:250,000.

[25] Ghasemi A., Hajhosseini A., Hosseini M., "Geological map of Chadegan", Geological Survey and Mineral Exploration of Iran (2006), Scale 1:100,000.

[26] Davoudian A. R., Genser J., Dachs E., Shabanian N., "Petrology of eclogites from north of Shahrekord, Sanandaj-Sirjan Zone, Iran", Mineralogy and Petrology (2007) 21p., DOI 10.1007/s00710-007-0204-6.

[27] BP, "Geological Map of Isfahan", British Petroleum Company Ltd., Survey Branch (1963), Scale 1:250,000.

[28] Boyer S.E., Elliott D., "Thrust systems", American Association of Petroleum Geologists Bulletin 66 (1982) 1196-1230.

[29] Berberian M., "Master "blind" thrust faults hidden under the Zagros folds: active basement tectonics and surface morphotectonics", Tectonophysics, 241, 1995, p. 193-224.

[30] Stipp M., Stünitz H., Heilbronner R., Schmid S.M., "The eastern Tonale fault zone: a ‘natural laboratory’ for crystal plastic deformation of quartz over a temperature range from 250 to 700 °C". Journal of Structural Geology 24 (2002)1861-1884.

[31] Hollister L.S., "Enrichment of CO2 in fluid inclusions in quartz by removal of H2O during crystal-plastic deformation", Journal of Structural Geology 12 (1990) 895-901.

[32] McCaig A. M, Tritlla J., Banks D. A., "Fluid mixing and recycling during Pyrenean thrusting: evidence from fluid inclusion halogen ratios", Geochima et Cosmochimica Acta 64 (2000) 3395-3412.

Files

History

  • Receive Date: 02 July 2025
  • Revise Date: 04 February 2026
  • Accept Date: 02 July 2025

Share

How to cite

Statistics