بررسی رفتار حرارتی سنگ معدن دولومیت شهرضا

نویسندگان

1 دانشگاه تهران

2 دانشگاه صنعتی سهند

چکیده

در این مقاله، رفتار حرارتی دولومیت شهرضا مورد بررسی قرار می­گیرد. همچنین هیدراته­شدن دولومیت کلسینه­شده در دماهای مختلف مطالعه شده است. نتایج، سه قله گرماگیر در دماهای ۸۰۰ ،۹۰۰ و ۱۰۵۰ درجه سانتیگراد را نشان می­دهد که دو  قله اول بترتیب مربوط به تجزیه کربنات منیزیم و کربنات کلسیم موجود در دولومیت، و قله سوم مربوط به تجزیه کلسیت آزاد است. نتایج همچنین نشان می­دهند که درجه کلسیناسیون با افزایش دمای کلسینه­کردن از ۸۰۰ تا ۱۴۰۰ درجه سانتیگراد، افزایش می­یابد. درجه هیدراته­شدن دولومی با افزایش دمای کلسیناسیون از ۸۰۰ تا ۹۰۰ درجه سانتیگراد به دلیل تشکیل فازهای آبگیر افزایش می­یابد. اما، سرعت هیدراته­شدن با افزایش بیشتر دمای کلسیناسیون کاهش یافته و در دمای کلسیناسیون ۱۴۰۰ درجه سانتیگراد ناچیز می­شود که این موضوع می­تواند ناشی از تفجوشی ذرات باشد.

کلیدواژه‌ها


عنوان مقاله [English]

An investigation on thermal behavior of Shahreza dolomite ORE

چکیده [English]

Thermal behavior of the Shahreza dolomite ore is investigated in this paper. The hydration of the calcined dolomite was studied as a function of the calcination temperature. The DTA results exhibit three endothermic peaks at 800, 900 and 1050 °C, corresponding to decomposition of MgCO3 and CaCO3, both are present in dolomite and free calcite, respectively. The results also indicated that the degree of calcination is increased by increasing the calcination temperature from 800 to 1400 °C. As the calcining temperature increases from 800 to 900 °C, the hydration degree of the dolime increases too because of more humid absorbing phases produced at higher temperature. However, the hydration degree declines with further increase in the calcination temperature and became negligible when the sample is calcined at 1400°C probably due to  the sintering process occurred at elevated temperatures.

کلیدواژه‌ها [English]

  • dolomite
  • Calcination
  • Hhydration
  • Sintering
  • Thermal analysis
[1] Roskill Information Services Ltd., "The economics of magnesium compounds", London, 6th edition (1990) 3-20.

[2] Garcia-Labiano F., Abad A., "Calcination of calcium-based sorbents at pressure in a broad range of CO2 concentration", Chemical Engineering Science, 57 (2002) 2381-2393.

[3] Rubiera F., Fuertes A., "Changes in textural properties of lime stone and dolomite during calciantion", Thermochimica Acta, 179 (1991) 125-134.

[4] Alfas P., Svedberg G., "Modeling of the simultaneous calcination, sintering and sulphation of limestone and dolomite", Chemical Engineering Science, 47 (1992) 1903-1912.

[5] Sridhar R., Ray H.S., "Extraction of Non-Ferrous Metals", Afflicted East West Press, New Delhi, 1st edition (1985) 130-131.

[6] Chester J. H., "Refractories, Production and Properties", The Iron and Steel Institute, London, 1st edition (1973) 189-198.

[7] Jain S.K., "Ore Processing", Indian Edition Series, Rotterdam, (1987) 43-49.

[8] Ersoy-Mericboyu A., Kucukbayrak S., "Kinetics analysis of non-isothermal calciantion TG curves of natural Turkish dolomites", Thermochimica Acta, 232 (1994) 225-232.

[9] Todor D. N, "Thermal Analysis of Minerals", Abacus Press,1st edition (1976) 171-172.

[10] Shi H., Zhao Y., "Effects of temperature on the hydration characteristics of free lime", Cement and Concrete Research, 32 (2002) 789-793.